building materials brick AAC surfacing adhesives ›› adhesives for ceramic tiles ›› adhesives for polystyrene mortar metal profiles
construction equipment plastering machines AAC cutting machine
HOUSE project house projects
comanda
Commercial Department
TEL: +40 244 33 78 17
FAX: +40 244 37 57 89
comercial.office@soceram.ro

SOCERAM DOICESTI
Street Aleea Sinaia, No 16
Doicesti, Dambovita County

SOCERAM BUCOV
Street Industriei, No 1
Bucov, Prahova County

SOCERAM URZICENI
Street Vanatorilor, No 1
Urziceni, Ialomita County

[+] more photos

Adhesives for ceramic tiles

Interior Adhesives | Adhesives for exterior

Surface application
For absorbent ceramic plates, on hard concrete or cement plaster, only for interior without excessive heat and humidity, with unevenness that does not exceed 5 mm/m

Application mode
The application support of the adhesive must be non-deformable, clean and without a release layer. Layers with low strength will be removed.

Product is sprinkled in cold and clean water, mix until a homogeneous paste, allow to rest 6-8 minutes then be reshuffled. The paste thus obtained is ready for use. Application is in a thick layer of 5-7 mm, a ribbed and uniform surface is made with a stainless steel plaster tool. Boards are pressed so that the board contact adhesive must be at least 65%. When applying at temperatures below 20°C setting and curing times are extended.

Application is made with a stainless steel plaster tool as needed, in thin and uniform layers (maximum thickness 2 mm). For application in several layers, layer will be applied successively after the previous layer strengthening (minimum 10 hours).
Surface can be polished after 24 hours. When applying at temperatures below 20°C the curing time is prolonged.

Working temperature 5°C …30°C
Mixture ratio 25 kg product / about 10 liters water
Estimated consumption 1.2 … 1.3 kg/mp, for one layer
with 1 mm thickness.
Commissioning work About 30 minutes since the paste
is prepared
The maximum assembly time of the support plate after applying paste 20 minutes
Minimum time to embroidered 24 hours
Time of putting into service 24 hours/vertical surfaces,
72 hours/horizontal surfaces
› ORDER NOW THIS PRODUCT 		Packing
Packaging is rated bags weighing 25 kg, 42 bags per pallet.

Storage
Indoors and dry, on pallet, in original packaging and undamaged, at temperatures between 5°C - 30°C.

Warranty
Shelf life of product is 12 months from the date of manufacture, provided to the prescriptions of transport and storage.